EQUATION GMA2845 Manuel D'instructions page 94

EN
USE
• Turn ON Set flame
brightness
• Standby mode
On / Standby
• Press on the control panel or the remote
control to start or standby the device.
Flame effect adjustment
• Press several times to choose a type of effect
F1 F2
Heating temperature adjustment:
• Press to activate the heating, the set
temperature is displayed
1 - From the control panel
• Maintain until the temperature flashes to enter the adjustment mode
• Press several times to choose the set temperature (desired temperature)
17 18 19
°C
°C °C
2 - From the remote control
• Set the temperature using the
The value " °C" sets heating on its maximum power without taking into account the room temperature.
ON
• After several seconds without action, the device comes out of the adjustment mode.
• Press again to deactivate the heating, the blower stops after 15 seconds.
Set Set Timer
température
Timer activated
Day of the week
• Set the time
• Program
F3 F4
20 21 22
°C °C °C
and buttons
heating Flame
indicator activated
Exit Program
Decrease
temperature
Activate heating
Set the flame effect
23 24 25
°C °C °C
94
Firewood sound activated
• Choose Flame
• Set temperature
• Set timer
Time display
Day of the week (program
mode)
Set Timer
Increase temperature
Validate
Activate programs
Lock the buttons
Adjust the sound effect
26 27 ON
°C °C °C