SilverCrest SRRK 3.7 A1 Mode D'emploi page 22

Wet cleaning of the blade unit
The shaving heads 8 of the shaving attachment 9 can be
cleaned with water.
1. Press the release button 10 on the shaving attachment 9, so
that the blade unit 8 opens.
2. Clean the blade unit 8 under running water. Allow the water
to flow through the shaving heads 8 from the inside to the
outside.
3. Allow the parts to dry completely.
4. Close the blade unit 8, so that it clicks into place.
Thorough cleaning of the blade unit
NOTE: for thorough cleaning, an ultrasonic bath is recommended.
1. Press the release button 10 on the shaving attachment 9, so
that the blade unit 8 opens.
2. Figure D: pull the blade unit 8 off the shaving attach-
ment 9 by overextending it.
3. Figure E: carefully turn the locking wheel 18 marked with
arrows against the direction of the arrows, until the holder of
the shaving heads 19 can be lifted off.
4. Clean all parts under running water, and then allow them to
dry completely.
5. Reassemble the blade unit 8.
6. Figure F: carefully turn the locking wheel 18 in the direc-
tion of the arrows, until the holder of the shaving heads 19
can no longer be lifted off.
7. Push the blade unit 8 and the shaving attachment 9 back to-
gether and close the blade unit 8, so that it clicks into place.
8. Push the shaving attachment 9 back onto the shaver 12,
and ensure that it clicks firmly into place.
20
GB