Setting The Temperature - Unitekno AKWA 18 SMART PLUS S Manuel D'installation, D'utilisation Et D'entretien

8. USE
8.1 Dispensing
It is possible to dispense water in doses or continuously:
- DISPENSING IN DOSES: Press the desired water button once and wait until dispensing is finish. It is
possible to stop the dispensing of the dose in advance by pressing the button again.
- CONTINUOUS DISPENSING: press and hold the desired water button, then release it to stop dispen-
sing.
Press to dispense filtered water at room temperature
Press to dispense cold water
Press to dispense sparkling water
8.2 Modifying the doses
It is possible to modify the doses of the water.
Quickly press the water button twice for which you want to change the dose: the appliance starts to
dispense water and the blue light flashes. Once the desired dose has been reached, press the same button
again to stop dispensing and memorise the dose. The flashing blue light turns solid blue.
8.3 Using the appliance with tank
CAUTION
The external tank has to be filled with drinking water only.
Do not put inside the external tank any other liquid different from water.
Never leave the tank empty when the appliance is on.
If the tank empties while the pump is running, immediately enter water in the tank with a carafe or a
bottle without moving it from its seat.
Always keep the tank covered with its lid.
Do not expose the machine and especially the tank to direct sunlight.

8.4 Setting the temperature

To adjust the water temperature, use the screw shown
in the figure.
Remove the drip tray.
Remove the front panel from the front. Tilt the
cylinder as shown in the figure and remove it from
its position.
5°C
3°C
OFF
8°C
Turning it in a clockwise direction decreases the temperature.
|
27
E N