Unitekno AKWA 18 SMART PLUS S Manuel D'installation, D'utilisation Et D'entretien page 24

5. FEEDING SWITCH (WATER MAINS - TANK)
5.1 Switching from water mains to external tank
Turn off the appliance. Close the stopcock. Disconnect the water mains pipe from the appliance. Place
the plug provided on the rear side of the appliance. Remove the plug placed on the top of the device by
pulling it upward. Place the tank on the upper side of the appliance.
5.2 Switching from external tank to water mains
Turn off the appliance. Remove the plug placed on the rear side of the appliance. Connect the
water mains pipe. Remove the tank from the upper side of the appliance. Place the plug on the
upper side of the appliance.
CAUTION
Do not use the appliance with the tank without the specific cap on the water supply!
Do not use the appliance connected to the water supply without the specific cap on the tank inlet holes!
The appliance works properly only if the unused water inlet is properly closed!
|
E N 24