Unitekno AKWA 18 SMART PLUS S Manuel D'installation, D'utilisation Et D'entretien page 25

6. INSERTING AND REPLACING THE FILTER
INSERTING A NEW FILTER
Remove the front panel from the front. Remove the packaging from the new filter. Note the date of the
installation on the filter using a permanent marker. To insert the filter, push upwards into position and
turn in an anti-clockwise direction.
When the filter has been replaced, press and hold the sanitization button for 5 seconds to start the
device.
REPLACEMENT OF THE FILTER
CAUTION
The filter should be replaced when the number of litres equal to the stated capacity has been dispensed, when
the stated maximum time of use has passed or when a reduction in the flow of cold or filtered water is noticed.
The filter should be replaced every time you perform the sanitization of the applicance.
Remove the front panel from the front. To remove the filter, turn it in a clockwise direction.
Insert then the new filter.
|
25
E N