Unitekno AKWA 18 SMART PLUS S Manuel D'installation, D'utilisation Et D'entretien page 23

4. INSTALLING WITH TANK
Position the appliance on a surface near a power socket.
Insert the supplied filter as described later.
Check the presence of a cap on the water mains connection on the back of the machine. Remove the
tank-connection cover by pulling it upwards.
Fill the upper tank with water (max 4.5 l) and position it above the dispenser, as shown in the figure.
Connect the power cord to the appliance and to the power socket.
Move the switch on the ON (I) position.
Press any button the pump starts to fill the system (carbonator). When the carbonator is full, the pump
stops.
Press and hold the sanitisation button until the power light turns off, then release it. The power light
switch on.
Connect the C02 cylinder as described later. Then open the C02 pressure regulator.
Dispense 1/2 litre of sparkling water, wait until the pump shuts off.
Repeat this operation 12 times, dispensing 6 litres of sparkling water in total.
Then dispense at least 1 litre of cold water and 1 litre of water at room temperature.
Refill the tank, if necessary, to complete the operation.
CAUTION
The external tank has to be filled with drinking water only.
Do not put inside the external tank any other liquid different from water
CAUTION
Never leave the tank empty when the appliance is on.
CAUTION
Don not use the appliance with the tank without the specific cap on the water supply!
05 cm
10 cm
05 cm
|
23
E N