Adjustment - Ergon BA3 Evo Enduro Mode D'emploi

13
EN
Recommendation for the adjustment of the back length (see table on the back page of these instructions).
To assess the correct fi t of your backpack, your height and clothing size can be used. All measurements are suggestions
and are based on average body sizes. Personal fi t and preference may vary.
Fig. 1 Fig. 2

Adjustment

Loosen the shoulder straps and put the pack on.
Fasten the hip belt. The hip belt is correctly
positioned when the top of the hip belt is follows
the line of the pelvis (+/- 3cm) and relatively tight.
It should not be positioned across the stomach
(Fig. 1). Tighten the shoulder straps until there is
little or no slack in the system. They should not
press into your shoulders. Sit on a bicycle, or on
a stool and mimic the position on a bicycle. The
coloured adjustment marks allow the user to
check that the hip belt is the correct size and the
back length is correctly adjusted. This is the case
when the coloured adjustment marks cross. If
this is not the case, please re-adjust the pack
(Fig. 2).
Automatic adjustment of the shoulder strap
angles
Thanks to the two D-rings at the top of the
shoulder straps, the carrying system has a
certain amount of automatic adjustment.