Adjustment - Ergon BX2 Mode D'emploi

ERGon BIKE ERGonoMICS
Fig. 1:
Fig. 3:
Recommendation for the adjustment of the back length (see table on the back page of these instructions).
To assess the correct fit of your backpack, your height and clothing size can be used. All measurements are suggestions and are
based on average body sizes. Personal fit and preference may vary. Visit the BX2 product page at www.ergon-bike.com to find a
detailed online-selector which will help you to find your personal adjustment.
Further information available at www.ergon-bike.com
Fig. 2:

Adjustment

Fig. 1: Loosen the shoulder straps and put
the pack on. Fasten the hip belt. The hip belt
is correctly positioned when the top of the hip
belt is follows the line of the pelvis (+/- 3cm) and
relatively tight. It should not be positioned across
the stomach.
Fig. 2: Tighten the shoulder straps until there is
little or no slack in the system. They should not
press into your shoulders. Sit on a bicycle, or on
a stool and mimic the position on a bicycle. The
green adjustment marks allow the user to check
that the Hip belt is the correct size and the back
length is correctly adjusted. This is the case when
the green adjustment marks cross. If this is not
the case, please re-adjust the pack.
Automatic adjustment of the shoulder
strap angles:
Fig. 3: Thanks to the two D rings at the top of
the shoulder straps, the carrying system has a
certain amount of automatic adjustment.
( GB/USA )