Philips GC4500 Serie Mode D'emploi page 11

Problem Possible cause
The steam boost You have used the steam
function does not boost function too often
work properly within a very short period.
(water leaks out of
the soleplate).
You have used the steam
boost function at a too low
temperature.
Flakes and Scales are formed inside the
impurities come soleplate.
out of the
soleplate during
ironing.
Water leaks from You have overfilled the water
the water filling tank.
door.
Water or steam You have not locked the Quick
leaks from the Calc release tray properly.
back part of the
iron.
The Quick Calc release tray is
damaged.
All manuals and user guides at all-guides.com
storage
1 Unplug the iron and empty the water tank. Let it cool down in a safe
place.
2 Wind the mains cord around the backplate of the iron and store it
on its heel.
troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Centre in your
country (see the worldwide guarantee leaflet for contact details).
Solution
Wait for a few seconds before you use the steam
boost function again.
Set an ironing temperature at which the steam
boost function can be used (●●● to MAX).
Use the Calc-clean funtion (see chaper 'Cleaning
and maintenance', section 'Calc-clean function').
Do not fill the water tank beyond the MAX
indication. Pour excess water out of the water
tank.
Take out the Quick Calc Release tray and clean
it using tap water. Use a piece of cloth to wipe
off scales in the opening of the back part of the
iron. Put back the tray and lock it. (See chapter
"cleaning and maintenance, section "Quick calc
release function).
Contact a consumer care center in your country
(see the world wide guarantee leaflet for contact
details).
EnGlish
11