Worx WX368 Mode D'emploi page 11

3. SwITCh LOCK (See Fig.B)
The switch trigger can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
switch trigger, place the direction of rotation
selector in the center position.
4. REVERSIBLE (See Fig.B)
For drilling and screw driving use forward
rotation marked "
left). Only use reverse rotation marked
" " (lever is moved to the right) to remove
screws or release a jammed drill bit.
wARNINg: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
5. TwO-SPEED gEAR CONTROL (See
Fig.C)
The drill has a two-speed gear control (11)
designed for drilling or driving at LO (mark is
1) or HI (mark is 2) speeds. A slide switch is
located on top of the drill to select either LO
or HI speed. When using the drill in the LO
speed range, the speed will decrease and the
drill will have greater power and torque. When
using the drill in the HI speed range, the speed
will increase and the drill will have less power
and torque.
gear I
Low speed range: for screwdriving or working
with large drilling diameter.
gear II
High speed range: for working with small
drilling diameter.
wARNINg: To prevent gear damage,
always allow the chuck to come
to a complete stop before changing the
direction of rotation or the two-speed
gear train.
6. ChuCK ADjuSTMENT (See Fig.D)
To open the chuck jaws rotate the front section
of the chuck (1). Insert the drill bit between the
chuck jaws and rotate the front section in the
opposite direction. Ensure the drill bit is in the
center of the chuck jaws. Finally, firmly rotate the
front chuck section in the opposite directions.
Your drill bit is now clamped in the chuck.
Lithium-Ion cordless hammer drill
All manuals and user guides at all-guides.com
" (lever is moved to the
7. TORquE ADjuSTMENT AND hAMMER
OR DRILLINg CONTROL (See Fig.E)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque
adjustment ring (2). The torque is greater
when the torque adjustment ring is set on
a higher setting. The torque is less when
the torque adjustment ring is set on a lower
setting.
When drilling in masonry and concrete choose
the hammer position
When drilling in wood, metal, plastic and
screwdriver choose the drill position .
Make the setting as follows:
1 - 4 for driving small screws
for driving screws into soft
5 - 9
material
for driving screws into soft and
10 – 14
hard material
15 - 19 for driving screws into hard wood
20 for driving larger screws
for heavy drilling
for drilling in masonry and
concrete
8. AuTOMATIC SPINDLE LOCK (See Fig.F)
The automatic spindle lock allows you to
use as a regular screwdriver. You can give an
extra twist to firmly tighten a screw, loosen
a very tight screw or continue working
when the battery energy has expired. For
manual screwdriver purposes, the chuck is
automatically locked when the tool is off.
9. SIghT LIghT
The sight (3) light allows you to keep a clear
view under less illuminated circumstances.
To turn on the light simply press the on/off
switch. When you release the on/off switch,
the light will go out.
10. LEVEL DRILLINg (See Fig.g)
The Bubble level (10) is recessed in the motor
housing on the top of the drill. It can be used
to keep the drill level during horizontal drilling
operation.
The Bubble level (10) is recessed in the motor
.
EN
11