Velleman HAA53 Mode D'emploi page 2

Fig. 1
Select an adequate position for installation then fix the screw with the plastic fixing plugs supplied.
STEP 2
Pierce the elliptical hole on the front half of the housing (P7 fig. 1) and use the cable with four or six strands of 22
AWG wire to connect the main unit with the terminals of the HAA53 (fig. 2).
Terminals T1 and T2 are connected to the main unit's 24h-loop.
Terminals T3 and T4 are connected to the instant or delay loop of the main unit.
Terminals T5 and T6 are connected to, respectively, the positive and negative pole of the 12Vdc power supply.
Fig. 2
Remark :
Fasten the screws of the terminals. Verify whether the wire connections, the terminal screws and the PCB are
mounted correctly.
STEP 3
The device is supplied with 4 different lenses : Each type of lens has its own number on the lens tab: wide angle (1),
long range (2), pet (3) & curtain (4). The lenses can easily be replaced (see also fig. 3) :
HAA53
All manuals and user guides at all-guides.com
2 VELLEMAN