Bella 14641 Manuel D'instructions page 9

Figure 8
10. Move the blade assembly to the food so that it lies flat against, and is centered on the spindle.
(See Figure 8.)
NOTE: Push firmly on the back of the protective blade cover into the food to assure a tight fit.
11. Turn the lock counter-clockwise to lock.
12. Place the food tray next to the food bed to keep spirals together while processing.
13. Remove the protective blade cover. (See Figure 9.)
14. Plug the cord into a 120V AC electrical outlet.
15. Press the ON/OFF switch. The veggie holder will begin to spin food against the cutting blades as
spiralized food spills out the back. The movable blade assembly holder slowly advances to the end
of the food bed. (See Figure 10.)
WARNING! To reduce the risk of severe injury to persons, keep hands and utensils away from
moving blades while spiralizing or removing spiraled food.
Figure 10
16. The Spiralizer will stop automatically. Press the ON/OFF switch to OFF.
IMPORTANT! The Spiralizer will remain ON and will automatically resume operation unless
the ON/OFF switch is pressed to OFF.
17. Turn the blade assembly lock dial clockwise to UNLOCK the blade assembly holder. Slide the blade
assembly holder away from the veggie holder.
18. Turn the sliding blade assembly holder lock dial to the counter-clockwise to the LOCK position.
19. Carefully remove the last food remnant from the veggie holder.
20. Check cutting blades before spiralizing more food. Following the detailed procedures described
in the "Cleaning Instructions" at the end of this instruction manual, dislodge food debris with the
cleaning brush and rinse well.
CAUTION: Do not touch the cutting blades with your fingers. Blades are very sharp and can cause
injury if touched. Use extreme care when handling the cutting blades.
21. Unplug the Spiralizer when not in use.
22. The unit should be used for maximum 1 minute at a time. Always make sure that you allow 1 minute
in between use.
All manuals and user guides at all-guides.com
Figure 9
Spindle
9