Bella 14641 Manuel D'instructions page 7

Before Using for the First Time
1. Your Spiralizer comes fully assembled, topped with the food tray. Carefully unpack the Spiralizer
and remove all packaging materials. Lift the food tray from the Spiralizer. Pull the power cord out
from the underside of the food bed.
2. Turn the blade assembly lock dial clockwise to UNLOCK the blade assembly holder. Slide the blade
assembly holder away from the veggie holder.
3. Make sure the sliding blade assembly holder is locked in position on the food bed. Turn the sliding
blade assembly holder lock dial counter-clockwise to the LOCK position.
4. Remove the blade assembly from the sliding blade assembly holder.
Press and hold the blade assembly RELEASE button located on the backside of the sliding blade
assembly holder. (See Figure 2.)
Figure 2
5. Firmly grasp the handle and carefully lift the blade assembly up and off the sliding blade assembly
holder. (See Figure 3.)
IMPORTANT: Make sure the sliding holder is locked before removing the blade assembly.
WARNING: ALWAYS grasp the protective blade cover's handle when removing the blade assembly.
Failure to do so can result in personal injury.
6. Remove the protective blade cover. Press down on the top of the blade cover to facilitate easy
removal. Lift the cover up and out of the bottom slots. (See Figure 4.)
Figure 4
7. Use the cleaning brush to rinse and wash the cutting blade warm, soapy water.
WARNING: Cutting blades are very sharp! Use extreme care when handling.
8. Wipe the Spiralizer motor base and food bed with a soft, moistened cloth.
WARNING: Never immerse the Spiralizer motor base in water or any other liquid.
9. Dry each part thoroughly before use.
10. Replace protective blade cover by inserting both tabs into the slots on the base of the cutting blade
assembly. Press down on the top of the blade cover to make sure the top tabs are enclosed and the
blade assembly is properly fastened.
WARNING: The cutting blades are very sharp! Use extreme care when handling.
CAUTION: Make sure the protective blade cover is locked into position when attaching or removing
the blade assembly. (See Figure 4.)
All manuals and user guides at all-guides.com
Figure 3
7