Bella 14641 Manuel D'instructions page 8

Operating Instructions
Adjusting the Spirals
1- 2 - 3 – 4
1-Ribbons
1. Before attaching the blade assembly onto the holder, check the spiral dial setting.
2. To change the spiral width, following the detailed procedures described in "Before Using for the
First Time" section of this instruction manual, remove the blade assembly.
3. Turn the spiral dial to change to any of 4 widths: 1, 2, 3 or 4. (See Figure 5).
Figure 5
CAUTION: Make sure the blade assembly is NOT attached to the unit.
CAUTION: Make sure the protective blade cover is locked into position when adjusting the spiral
setting, attaching or removing the blade assembly. (See Figure 4.)
4. Replace blade assembly into the sliding blade assembly holder. Push down firmly on the top of the
blade assembly. An audible click can be heard as the blade assembly locks into place. (See Figure 3.)
5. Prepare food to be spiralized. The Spiralizer works best with fruits and vegetables that have solid
flesh. Foods should be firm with no hard seeds or pits. Use with delicate fruits and vegetables, such
as tomatoes, is not recommended. Very hard foods that are impenetrable with an ordinary knife
should also be avoided.
6. Remove any thick peel or skin from foods before spiralizing. Trim food so both ends are flat. For best
results, food should be 1 to 3 inches in diameter and no longer than 6 inches long.
7. The Spiralizer makes continuous spirals of food.
HINT! For single coins, make a half-inch horizontal cut from the left to the right side -- to the center of
the vegetable or fruit. (See Figure 6.) Turn the spiral dial to #1 Ribbons to make beautiful paper-thin,
discs of cucumbers, carrots, potatoes, zucchini, etc. in minutes!
8. Unlock the sliding blade assembly holder.
9. Attach the vegetable or fruit to the veggie holder, press the prongs firmly into the left side of the food.
NOTE: For foods that are more difficult to attach, turn the veggie holder towards you to remove.
Place on a clean, flat surface. Gently press the food into the prongs so that the fit is secure.
(See Figure 7.) Replace the veggie holder; turn clockwise until it locks into position.
Figure 6
WARNING: Veggie holder prongs are sharp. Use caution when handling.
All manuals and user guides at all-guides.com
2-Fettuccine / Curly Fries
Figure 7
3-Linguine
8
4-Spaghetti