Publicité
Les langues disponibles
Les langues disponibles
OPERATION
To reduce the risk of injury, always
WARNING
wear proper eye protection marked
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Using the Drive Control
The drive control button is used to adjust the torque,
rotation speed (RPM), and impact speed (IPM) for
the application.
To select the drive control mode: Drive Control Button
1. Pull and release the trigger
to turn on the tool. The cur-
rent mode indicator is lit.
2. Press the drive control but-
ton
to cycle through the
modes. Select wireless
to change the default set-
tings via the ONE-KEY™
app on your smart device.
When the desired mode indicator is lit, begin work.
NOTE: Select the torque range in accordance with
the equipment manufacturers fastening instruc-
tions. For precision applications, confirm the final
tightening torque with a calibrated device.
Using the Control Switch
The control switch may be set to three positions:
forward, reverse and lock. Due to a lockout mecha-
nism, the control switch can only be adjusted when
the ON/OFF switch is not pressed. Always allow the
motor to come to a complete stop before using the
control switch.
For forward (clockwise) rotation, push in the control
from the right side of the tool. Check the
switch
direction of rotation before use.
For reverse (counterclockwise) rotation, push in the
from the left side of the tool. Check
control switch
direction of rotation before use.
To lock the trigger, push the control switch to the
center position. The trigger will not work while the
control switch is in the center locked position. Always
lock the trigger or remove the battery pack before
performing maintenance, changing accessories,
storing the tool and any time the tool is not in use.
ONE-KEY™
Mode Indicator
Direction Lock
Use the Direction Lock feature via the ONE-KEY™ app
to restrict the tool direction to either FORWARD or
REVERSE.
Control switch
in forward
ONE-KEY™
Direction
Tool will run in
Lock set to
forward only
FORWARD
ONE-KEY™
Tool will not
Direction
Lock set to
performance
REVERSE
indicator will light
ONE-KEY™
Direction
Tool will run in
Lock set to
OFF
Selecting Speed
Mode
RPM
1
0 - 1125
2
0 - 1525
3
0 - 1850
4
0 - 2325
Allow the tool to come to a complete stop before
changing speeds. Press the selector button
cycle between the settings.
ONE-KEY™ Enabled Modes
Scan the QR code below and read
WARNING
all instructions, illustrations, and
specifications for each of the enabled modes for
this tool. Use the proper tool mode and mode
settings in the ONE-KEY™ app for the intended
application. Property damage, flooding, break-
age, or other damage or failure can occur if the
mode's instructions are not properly followed.
Read all safety warnings, instructions, illustra-
tions and specifications supplied with the parts,
accessories, fixture, attachment, etc. Only
use with approved items as designated in the
ONE-KEY™ app.
Always confirm the final tightening torque with a
calibrated torque tool when precision fastening
is required.
Scan this QR code to access Operation
instructions and the most up to date
product use information.
To signify that the tool may be out of
an acceptable performance tolerance,
the LED performance indicators will flash. Refer to
the troubleshooting section in the ONE-KEY™ app.
The tool will still operate, but may not be delivering
the desired output.
5
Control switch
in reverse
Tool will not
run, LED
performance
indicator will light
run, LED
Tool will run in
reverse only
Tool will run in
forward
reverse
IPM
0 - 1650
0 - 2475
0 - 3000
0 - 3500
to
Publicité
