Carrera RC Red Eagle Instructions De Montage Et D'utilisation page 13

7
l r
8
l r
Troubleshooting
Problem Cause
Remote control The ON/OFF-power switch is turned "OFF".
does not work.
The batteries have been wrongly inserted.
The batteries do not have enough power.
The helicopter cannot be The power switch on the reomote control is turned "OFF".
controlled with the remote
control
The battery is not correctly plugged in to the battery holder in the
helicopter.
The remote control is possibly not correctly frequency bound with the
receiver on the helicopter.
The rotor blades do not rotate. The ON/OFF-power switch is turned "OFF".
The rechargeable battery is too weak or has run out of power.
The helicopter does not lift. The rotor blades rotate too slowly.
The battery´s power is not sufficient.
During flight, the helicopter
loses speed and height The battery is too weak.
without any obvious reason.
The helicopter lands too Loss of throttle control.
quickly.
Throttle has been pushed down too quickly.
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
When shifting the lever for right/left
pitch to the left or right, the helicopter
pitches to the left or to the right and flies
to the left and right respectively. Use
the timmer for right/left pitch in order to
achieve a stable neutral position and to
avoid that the helicopter will fly to the
left or right when hovering without
moving the lever for right-/left pitch
After having made yourself familiar with
the main control functions and having
chosen an appropriate area for flying
the helicopter, you can start the first
flight.
Choosing the flight area
When being prepared for the first flight you should choose a closed room without any
persons or obstacles which is as big as possible. Due to the size and controllability of
the helicopter experienced pilotes may be able to fly the helicopter in relatively small
rooms. For your first flights we strongly recommend to choose a room with a minimum
floor space of 3 x 3 metres and 2.40 metres of height. After having trimmed your heli-
copter for flight and having made yourself familiar with the controlling and its functions
you may start flying in smaller and less open environments.
The helicopter has exclusively been developed for indoor use in closed rooms.
For more information on our RC-products please visit carrera-rc.com.
Should you need spare parts, you will find a complete list of the available parts under
carrera-rc.com in the service area.
Solution
Turn the ON/OFF-power switch "ON".
Check if the batteries have been correctly inserted.
Insert new batteries.
First turn the power switch on the remote control "ON".
Push the battery up against the battery holder. Wait 3 seconds until
connection is established between the controller and the receiver.
Please carry out a frequency bind between the helicopter and the
remote control as described in "frequency bind between model and
remote control".
Turn the ON/OFF-power switch "ON".
Charge the battery (see chapter "Charging the battery").
Push the throttle up.
Charge the battery (see chapter "Charging the battery").
Charge the battery (see chapter "Charging the battery").
Push the throttle down slowly.
13