Husqvarna K1 PACE Notice D'utilisation page 34

To clean the cooling system
The product has a cooling system that keeps the
temperature of the product as low as possible.
The cooling system includes an air intake on the left side
of the product and a fan on the motor.
1. Clean the cooling system with a brush weekly or
more frequently if necessary.
2. Make sure that the cooling system is not dirty or
blocked.
CAUTION:
cooling system can cause the product to
become too hot.
To remove the drive belt
1. Remove the belt guard. Refer to
K1 PACE on page 3 .
2. Put the belt tool on top of the front pulley. Use a
wrench to pull the drive belt off the pulley.
To install the drive belt
1. Put the drive belt around the rear pulley.
34
A dirty or blocked
Product overview
2. Put the belt assembly tool on top of the front pulley.
3. Turn the front pulley clockwise with the combination
wrench. At the same time, push the drive belt onto
the pulley.
4. Attach the belt guard. Refer to
PACE on page 3 .
To do a check of the water supply system
1. Examine the nozzles on the blade guard and make
sure that they are not clogged.
2. Clean as necessary.
3. Examine the filter on the water connector. Make sure
that it is not clogged.
4. Clean as necessary.
5. Examine the hoses and make sure that they are not
damaged.
Product overview K1
1598 - 006 - 06.09.2023