Husqvarna K1 PACE Notice D'utilisation page 22

•
2
•
3
•
• Make the final separating cut from the top of the
pipe pulling backwards, without involving the upper
quadrant of the blade. Adjust the blade guard to full
forward position for maximum protection.
WARNING:
supported, it should not pinch the blade
when separated in section 5. However
be alert if the blade is pinched during the
final separation. If the blade is pinched
in the lower section, the product may pull
forward away from the operator, rather
then resulting in a rotating kickback.
22
4
5
If the pipe is properly
To prevent a kickback
WARNING:
there is a risk of kickback. Take care when
using your power cutter and make sure that
the blade is never pinched in the kickback
zone.
WARNING:
the blade in an existing cut.
WARNING:
work piece cannot move during a cutting
operation.
WARNING:
working technique can eliminate kickback
and its dangers.
• Always support the work of piece so that the cut can
keep open when cutting through. When the cut is
open there is no kickback. If the cut is closed and
pinches the blade, there is a risk of kickback.
To do before you use the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 32 .
3. Make sure that only approved persons are in the
work area.
4. Make sure that you are in a safe and stable position
during operation.
5. Make sure that the water connector is connected
to a water supply. Refer to
water on page 26 .
6. Do a check of the rear handle (A) to make sure that
it is not damaged.
C
B
A
Avoid situations where
Be careful when you put
Make sure that the
Only you and proper
Maintenance
To connect the coolant
1598 - 006 - 06.09.2023