Husqvarna K1 PACE Notice D'utilisation page 19

1. Make sure that the threads on the spindle shaft are
not damaged. Replace damaged parts.
2. Make sure that the areas of contact on the cutting
blade and the flange washers are not damaged.
Replace damaged parts.
3. Make sure that the flange washers are clean and of
the correct dimension.
4. Make sure that the flange washers move freely on
the spindle shaft.
To install the cutting blade
WARNING:
off and that the battery is disconnected.
WARNING:
gloves when you assemble the product.
1. Examine the flange washers and the spindle shaft.
To examine the spindle shaft and the flange
Refer to
washers on page 18 .
2. Put the cutting blade on the arbor bushing (A)
between the inner flange washer (B) and the flange
washer (C). Turn the flange washer until it holds on
to the shaft.
B
1598 - 006 - 06.09.2023
Make sure that the motor is
Always use protective
A
C
3. Put a tool into the hole in the belt guard and turn the
cutting blade until the shaft is locked.
4. Tighten the cutting blade bolt to 30 Nm/18.5 ft-lb.
Strap eyelet (K1 PACE Rescue)
The product has 2 strap eyelets. The eyelets are used to
attach the shoulder strap.
19