Nanosonics trophon Printer Mode D'emploi page 7

Figure 3
1.2 Printer – Initial Set-Up
 Unpack the printer from its packaging
 Position the printer securely on a bench beside the trophon device. The trophon Printer Wall
Mount or trophon Printer Cart Mount accessories should be used to mount the printer to the wall
or cart.
 Follow the setup instructions in Appendix A for powering on the printer and connecting it to your
trophon device.
NOTE: Ensure the printer power cable is connected to the printer before connecting to an earthed
mains outlet or switching power switch to on position.
NOTE: Keep the label roll holders in the "unlock" position. Please note the orientation of the label roll
holders in Figure 3, as they can be rotated. Incorrect orientation will prevent correct loading of the label
roll into the printer.
2. INSTRUCTIONS FOR USE
 Once the printer is connected to the trophon device via the appropriate cable provided (either
USB or serial cable, depending on the port available on your trophon device) and powered on,
the printer will be automatically detected.
 It is recommended to complete a test print to confirm successful connection to the device.
 Test prints and all other printer settings can be accessed on the trophon device screen by
selecting either Menu
device.
3. ROUTINE CARE AND MAINTENANCE
3.1 Replacing printer Label Roll
The trophon device will display an onscreen notification when the label roll requires replacement.
Follow the setup instructions included in Appendix A to load the label roll.
L00137 1.0 11/2017
All manuals and user guides at all-guides.com

Printer or System Setup
Printer (interior)
12. Top cover
13. Printer head
14. Label roll holders
15. Label roll guides
16. Optical sensor
17. Label roll holder lock
(a) Unlock
(b) Lock

Printer Settings. Please check your trophon
5