Ryobi P26010 Manuel D'utilisation page 45

TO INSTALL/REMOVE BATTERY PACK
See Figure 4.
WARNING:
Always remove battery pack from your tool
when you are assembling parts, making adjust-
ments, cleaning, carrying, transporting or when
not in use. Removing battery pack will prevent
accidental starting that could cause serious
personal injury.
To install:
 Insert the battery pack into the product as
shown.
WARNING:
Make sure the latches on the battery pack snap
in place and the battery pack is fully seated
and secure in the battery port before beginning
operation. Failure to securely seat the battery
pack could cause the battery pack to fall out,
resulting in serious personal injury.
To remove:
Locate latches on side of battery pack and de-
press both sides to release the battery pack from
the pole saw.
WARNING:
To avoid serious personal injury, always remove
the battery pack and keep hands clear of the
lock-out button when carrying or transporting
the tool.
For complete charging instructions, see the opera-
tor's manuals for your battery pack and charger.
STARTING AND STOPPING
See Figures 4 - 5.
To start the motor:
 Hold the pole saw as shown and ensure that you
are well away from anything that may contact
the blade.
 Press and hold the trigger lock-out.
 Depress the switch trigger.
OPERATION
To stop the motor:
 Release the trigger to stop the pole saw. Upon
release of the trigger, the trigger lock will auto-
matically reset to the locked position.
11 — English
LOCK-OUT
BUTTON
SWITCH TRIGGER
BATTERY
Fig. 4 Fig. 4
Fig. 5 Fig. 5