Safety Instructions; User Responsibility; Wiring Diagrams - LEMAN RAD260 Manuel D'utilisation

10.1 Regularly clean the thicknessing bed spindles from
chips and dust and lubricate with spray oil. Do not use
regular oil.
10.2 Keep infeed/outfeed tables and thicknessing bed free of
resin. Clean regularly with kerosene or petrol, then coat
with a light film of wax antiseizing paste to enhance
gliding of stock on table.

11.0 Safety Instructions

- Regularly check that blades and lock bars are
locked tight in cutterblock
- Max. allowable blade projection over cutterblock 1.0 mm/0.04 inch +10%.
- Never remove any of the machine's safety guards other than for servicing and repair work. Keep guards operational at all
times.
- Set and secure safety guards in position before operating machine.
- When operating machine in enclosed spaces connect to a dust collector.
- This machine must be safety earthed. The yellow/green (green) lead is the earth conductor.
- Regularly check anti-kickback fingers for proper operation.
- Always wear eye protection.
- Rebating, tenoning, moulding and recessing may not be undertaken without the use of special guards.
- Never make jointing or planing cut deeper than 3 mm or 1/2".

12.0 User Responsibility

This machine will perform in conformity with the description contained in this manual when installed, operated, maintained
and repaired in accordance with the instructions provided.
This machine must be checked periodically. Defective equipment (including power cable) should not be used. Parts that are
broken, missing, plainly worn, distorted or contaminated, should be replaced immediately. Should such repair or
replacement become necessary, it is recommended that such repairs be carried out by qualified persons.
This machine or any of its parts should not be altered or changed or changed from standard specifications. The user of this
machine shall have the sole responsibility for any malfunction which results from improper use or unauthorized
modification from standard specification, faulty maintenance, damage or improper repair.

13.0 Wiring diagrams

Wring diagram for motor 230V 50Hz Wring diagram for motor 400V 50Hz
10
EN