Everglades EVTTHAPPY Mode D'emploi page 37

All manuals and user guides at all-guides.com
Choose a location where there is no heat source. Keep the refrigerator away from direct
sunlight or other appliance producing heat.
Choose a dry and well-ventilated place where there is no corrosive air.
TEST
Clean the parts of the refrigerator with lukewarm water on a soft cloth or with a neutral
detergent and with clear water, then wipe them dry.
Notes: Electric parts of the refrigerator can only be wiped by dry cloth.
Turn the thermostat knob on the "3" position and turn on electricity. The compressor
and the light inside the refrigerator begin to work.
Close the door and wait 30 minutes. If the temperature in the freezer compartment
decreased obviously, it shows that the refrigerator system works well. When the
refrigerator operates for a period of time, the temperature controller will automatically
set the temperature on conditions that the door is not too often opened.
If the above steps are successful, the trial operations are finished. The refrigerator works
normally.
TEMPERATURE CONTROL
The temperature is controlled by the temperature controller installed on the right side
of the fridge compartment.
Turn the thermostat knob to regulate the temperature inside the refrigerator.
The marks on the knob are not the exact number of the degrees of temperature but the
temperature grades from "0" to "7". The first grade corresponds to a forced STOP of the
refrigeration and the 7th grade corresponds to the lowest temperature the refrigerator
can produce. Turn the knob from "1"position to "7"position, the temperature decreases
continuously.
Set the thermostat knob to "3-4"position for a normal use.
Notice that the product is set for operation at a specific ambient range between 16 and
38°C. The appliance may not work properly if it is left for a long period at a temperature
above or below the indicate range.
630
-6-
1130
854