Publicité
Turn on the RC System
CAUTION!
Always turn the transmitter´s
power switch ON first!
To turn on the transmitter, press the
power button (LED on). To turn off the
transmitter, re-press the power button (LED off).
1 Connect the rechargeable battery for the driving.
2 Switch on the receiver.
3 Put the body on and fix it with the body split pins.
1
BINDING THE 2.4 GHz RC-System
The modern 2.4 GHz system requires no more crystals and is com-
pletely Insensitive to interference.
Occasionally, it may be that lose the connection of model to the
transmitter.
Meets this happens, you must observe the following steps:
Binding cable
All manuals and user guides at all-guides.com
2
1 Turn off the transmitter and car.
2 Hold CH3 button pressed on the transmitter and turn on the trans-
3 Now insert the binding cable supplied in the servo socket and
4 Turn off the receiver and the transmitter and switch on again. Now
3
mitter at same time. The blue LED will start to congestion flash.
switch on the receiver. The binding process is now complete. Next
remove the binding cable and replace it with the servo cable.
you can operate.
Servo cable
ON
G
19
Publicité
