Kopp Free-control Mode D'emploi page 40

GB
1-button mode means:
Switch ON-OFF at the same position on the
mini handheld radio transmitter
2-button mode means:
Switch ON at one position of the wire-
less transmitter mini Switch OFF at a
different position on the mini handheld radio
transmitter
The radio dimmer receiver cannot be
programmed and operated in 2-button mode,
only in 1-button mode. If dimmer receivers
are programmed in 2-button mode, the re-
ceiver can only be switched, not dimmed!
40
170120_KOPP_BA_05873300_FC_Funk-Handsender_mini.indd 40
Delete programmed assignments (brief
instructions):
(applies for free-control radio receiver. Note
the "Operating Instructions" section)
1. Press the PROG button of the radio
receiver with the enclosed programming
pin for approx. 10 seconds until the LED
lights up (red) and then goes out
2. After approximately 3 seconds the LED
lights up.
3. After a further 7 seconds the LED lights
flashes twice.
4. Ready – All programmed allocations are
now deleted. Ready to programme new
radio transmitter.
20.01.2017 09:34:12