ARCHEON EOlife X Instructions D'utilisation page 11

Switch off EOlife X by pressing the ON/OFF button for 3
12
seconds or by quick pressing the ON/OFF icon on the touch
screen
Switching off using
the summary screen
VIII. Detailed product description and operating instructions
EOlife X is controlled via the touch screen and the physical ON/OFF button .
Caution
Avoid using any object that could scratch the screen .
1. Using the device
a) Assembly/disassembly
Assembly
FlowSense X is factory calibrated . Once removed from its packaging FlowSense X is ready to be used .
Remove the FlowSense X sensor from its packaging by using the notch to tear the antistatic bag to avoid damaging
the sensor .
Connect the FlowSense X sensor to the EOlife X unit, taking care not to expose the printed circuit board to dust or
splash it with water .
First insert the part of the FlowSense X with a notch into the connector ridge, and then press firmly on the sensor so
that it comes into contact with the connector pins . You will hear a click when the connector tab holds the FlowSense
X sensor in place .
Check that the FlowSense X sensor is held properly in place before starting up the EOlife X unit .
Tab
Notch
Ridge
Disconnect the ventilation bag and interface
13
(mask or endotracheal tuve) and unclip
the FlowSense X sensor by pulling the tab
outwards, as shown by the arrow
Disconnecting EOlife X
click
EN
11