Selco Genesis 1700 AC/DC Manuel D'instructions page 41

4 ACCESSORIES
4.1 General
Operation of the remote control is activated when connected
to the Selco power sources. This connection can be made also
with the system power on.
With the RC control connected, the power source control panel
stays enabled to perform any modification. The modifications
on the power source control panel are also shown on the RC
control and vice versa.
4.2 RC 100 remote control
The RC 100 is a remote control unit designed to manage the
display and the adjustment of the welding current and voltage.
"Consult the instruction manual".
4.3 RC 120 pedal remote control unit for TIG
welding
Once the power source has been switched
to the EXTERNAL CONTROL mode, the
output current is controlled from a mini-
mum to a maximum value (can be entered
from SETUP) by varying the foot pressure on
the pedal surface. A microswitch provides
the start trigger signal at minimum pressure.
4.4 RC 180 remote control
This remote control unit makes it possible to change the output
current without interrupting the welding process.
"Consult the instruction manual".
4.5 RC 200 remote control
The RC 200 is a remote control unit designed to manage the
display and the adjustment of all available parameters of the
power source to which it is connected.
"Consult the instruction manual".
4.6 ST... series torches
"Consult the instruction manual".
4.7 ST...U/D series torches
The U/D series torches are digital TIG torches allowing the main
welding parameters to be controlled:
- welding current
- program recall
(Consult the "Set up" section).
"Consult the instruction manual".
4.8 ST...DIGITIG series torches
4.8.1 General
The DIGITIG series torches are digital TIG torches allowing the
main welding parameters to be controlled:
- welding current
- program recall
Parameters 3-4 can be personalised.
(Consult the "Set up" section).
"Consult the instruction manual".
41