BEBE CONFORT CabrioFix Mode D'emploi page 17

Shell
1
Belt buckle
2
Crotch strap with belt pad
3 a
Shoulder belts with belt pads
3 b
Slots to adjust shoulder belts
4
Support pillow
5
Carrying handle
6
Push button for adjusting carrying handle
7
Belt hook for lap section of safety belt
8
Rear belt hook for shoulder section of safety belt
9
Belt tensioner strap
10
Control button of the quick adjuster
11
Control button for removing car seat from
12
Bébé Confort or Quinny frame
Belt hooks
13
Instuctions and airbag warning sticker
14
Rim (for storing sun canopy)
15
Sun canopy (built-in)
16
Instruction manual
17
Storage compartment
18
Mounting bars for FamilyFix
19
Safety
General CabrioFix instructions
1. You are personally responsible for the safety of your
baby at all times.
2. Never hold your baby on your lap when driving.
3. The CabrioFix is developed for an intensive use of
approximately 10 years.
4. We advise to check the expanded polystyrene (EPS)
All manuals and user guides at all-guides.com
5. Do not use second-hand products whose history is
6. Replace the CabrioFix when it has been subject of
7 Read this instruction manual carefully and keep it in
WARNING :
CabrioFix whatsoever, as this could affect the
performance of the car seat and render it unsafe.
WARNING :
partially buckled harness straps. Fully restrain the child
even when carrier is used outside the vehicle.
The CabrioFix and your baby
1. Never leave your baby unattended.
2. Always secure your baby with the harness belt.
3. Before every use, make sure the harness is not
4. Make sure you can fit no more than one finger
5. Only use the support pillow of the CabrioFix when
WARNING :
elevated surface (such as a table or chair).
parts regularly for damages.
unknown. Some parts could be broken, torn or
missing.
violent stresses in an accident: the safety of your
child can no longer be guaranteed.
the storage compartment in the CabrioFix.
Do not make any changes to the
Children have STRANGLED in loose or
damaged or twisted.
between the harness and your baby (1cm).
the shoulder belts are in the lowest position.
Never place the CabrioFix on an
EN
19