Publicité
Les langues disponibles
Les langues disponibles
Sleeping mode
•
Press key "SLEEP" enter into sleeping mode, default value of fan speed is low.
• When sleeping mode turns on , under cooling mode, the fi rst one hour later, setting temperature
will go up 1℃, the second one hour later, setting temperature will go up another 1℃, and then keep
the same .
•
Sleeping mode is invalid under dehumidifying and fan mode. Under water full, machine standby
and mode conversion, sleeping mode will be cancelled.
Compressor protection
• Three minutes later after power on / restart, compressor starts to run.
This machine with auto-water-evaporating system. Condensed-water cycle to cool down the
condenser, which will not only improve cooling effi ciency, but also save energy.
•
If inner water tank is full, "
buzzer shouts , compressor stops and all keys is invalid till machine recovers to be normal.
•
Pull out the plug to drain out water, power off the machine and restart it , the machine will runs
normally.
Special caution for heating mode!
When heating mode works, if don't want to empty the water-tank under this mode, please connect a
water-drainage-pipe to remove the water out continuously.
1. Remove the drain knob
2. Remove the rubber plug and keep it for future use
3. Fix the drain connector into the drain knob.
4. Fix the drain knob to the water-outlet of the unit.
5. Connect one end of the drain pipe (ID:10mm) into the water outlet as following and put the other
end into a water-container.
Note: The water-container must be at or lower the outlet level.
Note: in order to avoid electric shocks, please power-off the machine and pull out plug before
maintenances or repairs.
Water Drainage
" will fl ashed on the screen , machine enter into standby mode,
Maintenance
14
Publicité
