Niko 350-30010 Mode D'emploi page 28

350-30010 350-20011
350-20010 390-20010
(IP54) cap (390-20010) (fig.4). Bear in mind that partitions, glass,
plants, furniture ... block the 'beams' (fig.5a,b).
2.2. Installation
General
- Open the motion sensor by inserting a screw driver in the notch
at the bottom and turn (fig.4).
- Insert the cable in the motion sensor and connect the wires to
the provided terminals. Close the motion sensor.
- Fit the sensors on a wall with the bracket supplied or directly in
a corner.
Motion sensor 350-20010 / 350-30010
You can easily set the motion sensors by bending the bracket (fig.6). V
indicates the bending angle and M the range in metres (fig.10a). For a
max. range, the sensors have to be fitted flat against a wall (V=0°). The
lens takes into account the necessary inclination to the ground.
Motion sensor 350-20011
When using the sensor in racks, angle the outer motion sensor
45° (fig.10b). This way, detection outside the rack can be avoided
(fig.1b;2b).
2.3. Connection diagrams
- 350-30010 (fig.7)
- 350-20010 / 350-20011 (fig.8)
- Parallel connection of motion sensors (fig.9)
Max. 8 sensor per control module, if more motion sensors are
required, provide an additional 24V DC power supply (e.g. 360-37000
or 360-47001).
23 EN