Ryobi EAG950RBD Traduction Des Instructions Originales page 5

there is considerable vibration or if other defects are
detected. If this condition occurs, check the tool to
determine the cause.
j) Do not use separate reducing bushings or adapters to
adapt large hole grinding wheels.
k) Check that the workpiece is properly supported.
l) Use only grinding wheels approved by RYOBI.
m) Ensure that sparks resulting from use do not create
a hazard, e.g., do not hit people, or ignite flammable
substances.
n) Always use protective safety glasses and ear protectors.
o) Use other personal protective equipment such as
gloves, apron and helmet when necessary.
p) Never place the tool on the floor or other surfaces while
it is running. Grinding wheels continue to rotate after
the tool is switched off. Never touch the wheel or place
it on the floor or other surfaces while it is rotating.
q) Use the tool only for approved applications. Never use
coolants or water or use the tool as a fixed tool.
r) Grip the tool securely with both hands while operating.
INTENDED USE
■ Grinding metal or cutting materials such as metal or
stone.
Do not use this product in any other way other than those
stated for intended use.
MAINTENANCE
WARNING
The product should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
accidental starting that could cause serious injury.
a) When servicing, use only original manufacturer's
replacement parts, accessories and attachments.
Use of any other parts may create a hazard or cause
product damage.
b) Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
c) Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
d) Always wear safety goggles or safety glasses with
side shields when operating or cleaning the product. If
operation is dusty, also wear a dust mask.
e) If the supply cord of this power tool is damaged, it must
be replaced by a specially prepared cord available
through the service organization.
f) For greater safety and reliability, all repairs should be
performed by an authorised service centre.
g) All of the bearings in the product are lubricated with
a sufficient amount of high grade lubricant for the life
span of the product under normal operating conditions.
Therefore, no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging
environmental-friendly recycling.
SYMBOLS
Safety Alert
n
Rated speed
Class II tool, double insulation
Please read the instructions carefully
before starting the product.
Wear ear protection
Wear eye protection
Wear dust mask.
Do not use chipped, cracked or
defective grinding wheel
Not for wet grinding. Using water or
other liquid coolants may result in
electrocution or shock.
Not for face grinding
For cutting stone
Wear safety hand gloves
Wear non-slip safety footwear when
using this equipment
Wear personal protective equirment
English
should be sorted for
3
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
EL
TR