Fortec Star DVB-786v3 Mode D'emploi page 19

new TP name will be entered. When finished, press ESC and select STORE and press OK.
3. TO SORT TP LIST
Press OK on 'Sort'. The TPs you have added will be sorted by frequency. Lower frequency TP's will be moved to the top of the
list and vise versa.
4. TO EDIT EXISTING TP
Select the TP menu and press OK once. The cursor will move to list. Press CH or PAGE up / down to scroll through the list.
Press OK on the TP you want to edit. Enter channel data as described in step 1 above.
Network Information Table
NIT (Network Information Table) SEARCH
When downloading channels using this method, it will first Auto tune the TP's in the receiver's database. Then, it will search for
any NIT information, which may be broadcast by the service provider, from the signal available and subsequently tune those TP's
which are not included in the database.
The additional TP channels will be added to the TV Channel list at the bottom.
SIGNAL BAR INDICATIONS
In the Channel Search and viewing mode (when the channel banner is displayed) the signal bar will indicate the signal conditions
as shown below:
Blue signal: Indicates noise only, with no actual signal.
Green signal: Indicates signal .
RADIO MODE
When in radio channel mode, the TV screen will display a background picture.
Receiver to receiver copy function
If you have tuned your satellite receiver then you can copy the channel and user-setting data onto another receiver of the same
make and model. To do this you require a female-to-female 'NULL Modem' cable with the pin configuration as shown. To copy
proceed with steps below.
CABLE PIN CONFIGURATION
1
2
3
4
5
Upgrading the software of your receiver
You can upgrade the software of your receiver. When upgrade software is available, it can be accessed through our Web site
www.fortecstar.com. If you do not have access to Internet, then consult your Fortec Star Dealer / Agent for any upgrades.
Your current software version is displayed in the 'System Information' in the SYSTEM menu.
Remember, after a software upgrade, the receiver must be reset via the 'Master Reset' in the SYSTEM menu and then re-
installed.
If you have a problem with your receiver
All manuals and user guides at all-guides.com
ADD or RENAME a TP
Press CH up / down to move up and down the lines.
Press VOL up / down to move within the line.
Press OK on the letter to enter.
After naming, press ESC.
STEPS
4
1. Connect your lead to 'RS232' connectors (R11) on both the receivers.
3
2. Power on the master receiver from which you want to copy the data.
2
3. Power on the slave receiver onto which you want to copy the data.
1
4. The front display on the master receiver's will start counting up. When
5
transfer is finished it will indicate 'END'.
5. When finished the slave receiver will indicate a channel number e.g.
0002 or NOCH.
19