Publicité
Les langues disponibles
Les langues disponibles
LNB Type: Press VOL up / down and select ' Wide'. After selecting, press OK to configure the LO settings, if different.
LNB Power: Press VOL up / down and select '18V Skew On'. This will switch your LNB to higher band.
STORE: Press OK to store the settings.
22KHz Tone: When using an LNB application other than Universal LNB, press VOL up / down to select tone status.
INSTALL MENU: CHANNEL SEARCH
1. Antenna: Press VOL up / down and select reference 1.
2. Satellite: Press VOL up / down and select the satellite name.
3. Search Mode: Press VOL up / down and select the type of search.
4. TP Data: Press OK and select a lower band TP. Press OK on selected TP.
5. LNB Skew: Press VOL up / down to adjust skew until you see the maximum signal (green) on the signal bar.
6. START: Press OK to start search. This will tune all channels relating to the skew polarity in lower band.
7. When the above steps are finished, repeat steps 3 to 8 by selecting Antenna 2, and then selecting a TP from higher band.
This will tune all channels relating to the skew polarity in the higher band.
Changing satellite or channel in viewing mode
There are two ways of changing to a different satellite or channel. Each way is shown below.
TO SORT THE CHANNEL LIST
Press the green button on your remote to sort channels alphabetically.
Press the yellow button on your remote to sort channels by free-to-air first, followed by the scrambled channels.
Press the red button on your remote to return to normal list.
In both cases, if you select a channel from another satellite, the antenna will automatically move to that satellite.
TO RECALL THE LAST CHANNEL VIEWED
Press RECALL once on your remote. If you press again, it will go back to previous channel.
Viewing Teletext
The receiver has a built in Teletext circuitry which enables you to call up the text pages when they are transmitted by the service
provider.
All manuals and user guides at all-guides.com
BY PRESSING - OK
While watching any channel, press OK and the channel list will come up on your
screen.
TO SELECT A CHANNEL WITHIN THE SAME SATELLITE
Press CH up / down to scroll through the list individually or press PAGE up / down
to change the page. Press OK to select the desired channel
TO SELECT A CHANNEL FROM ANOTHER SATELLITE
Press VOL up / down to change the satellite. Then Press CH up / down to scroll
through the list individually or press PAGE up / down to change the page. Press
OK to select the desired channel on the chosen satellite.
BY PRESSING - SAT
While watching any channel, press SAT and the channel list will come up on your
screen with the current satellite highlighted.
TO SELECT A CHANNEL WITHIN THE SAME SATELLITE
Press OK, then scroll through the list individually or press PAGE up / down to
change the page. Press OK to select the desired channel.
TO SELECT A CHANNEL FROM ANOTHER SATELLITE
Press CH up / down to scroll through the satellites on the right. Once the channel
list has changed, press VOL down. This will enter the channel list on the left.
Then Press CH up / down to scroll through the list individually or press PAGE up /
down to change the page. Press OK to select the desired channel for the chosen
satellite.
12
Publicité
