Fortec Star DVB-786v3 Mode D'emploi page 13

To enter the Teletext mode, press TEXT (green) on your remote. If the service provider provides Teletext transmission, then the
text page will be displayed after a few seconds. If there is no Teletext transmission then a message will appear stating 'No TEXT
available'
To select a page, enter using 0-9 buttons.
To change to next page, use the PAGE up / down buttons.
To exit from Teletext mode, press TEXT button again or press ESC.
To display subtitles on a channel
If the service provider is transmitting subtitles for a channel, then you can select this by pressing the SUB.T (yellow) button on
your remote. The screen will display the menu in the top left corner. Press CH up / down button to select, then press OK. The
subtitles will appear after a few seconds after the channel banner has switched off. If there is no subtitle transmitted then a
message will appear which states 'No Subtitle available'.
NOTE: At times, the subtitle menu will appear on the top left corner but there may not be any subtitles transmitted.
To select a different broadcast audio
When the service provider is transmitting multiple audio or languages for a channel, you can select an audio or language of your
choice. Press the LANG button on your remote. The screen will display the menu on the top left corner. Press CH up / down
button to select, then press OK. The audio or language will change after a few seconds.
If you have connected your TV using a SCART lead, then you can further configure the audio output by pressing the A.MODE
(blue) button on your remote. Press repeatedly to change. The change will be indicated on the channel banner.
To activate sleep timer
To switch on the sleep timer, press the SLEEP button. The time will be displayed in the top right corner. You can program the
timer for a maximum of 2 hours. Press this button repeatedly to incrementally change the time. After the set time has lapsed, the
receiver will automatically switch to Standby mode.
INFORMATION
By pressing INFO button once on your remote, channel banner (shown below) will be displayed for 5 seconds. If you press the
INFO button twice, then channel data will appear above the channel banner.
CHANNEL BANNER
CHANNEL TYPE
SATELLITE
All manuals and user guides at all-guides.com
PROGRAM NUMBER
CHANNEL NAME
SIGNAL STRENGTH
GREEN = SIGNAL
13
AUDIO OUTPUT
SCRAMBLED
CHANNEL
TIME DISPLAY
CHANNEL LIST