Fortec Star DVB-786v3 Mode D'emploi page 11

Channel search: Individual satellite
To tune satellites individually or to add more satellites after multi satellite search, follow steps below.
INSTALL MENU: CHANNEL SEARCH
1. Search Index: You do not need to set anything here. The reference can be left as 1.
2. Antenna: Select antenna reference as configured previously. If you are using a different LNB type, then select that reference.
Press VOL up / down to change reference number.
3. Satellite: Press VOL up / down to change the satellite name.
4. Search Mode: Select search type for the satellite you wish to search. (See types indicated on page 9.) Press VOL up / down
to change the type.
5. TP Data: Select a predefined TP. Press OK to display the sub menu, then press VOL up / down to change the TP. Finally,
press OK on the selected TP. This TP will then be entered on the main channel search page.
6. Positioner: If you are using a DiSEqC antenna positioner then select one of the options from below. Press VOL up / down to
change and press OK for the sub menu. If you only have a fixed antenna installation, then select 'None' and proceed with step 7
below.
A) Using the DiSEqC 1.2 menu, manually move the antenna until you find the correct position and signal. In this
menu, select 'MOVE' then press VOL up / down to move the antenna until you find the correct position at the
point when signal bar turns green and is at a maximum level. Then select STORE and press OK. This will store
the satellite position.
B) Using the DiSEqC 1.3 menu, automatically move the antenna to the correct position. In this menu, select
'USALS' and press OK. The antenna will automatically move to the correct position. After the antenna has
stopped moving, the signal bar will turn green indicating presence of a signal. Then select STORE and press
OK.
7. START: After completing the above configuration, move down to START and press OK to commence search. The screen will
change (illustrated above) as TV and Radio channels are downloading. When download is completed, it will store the channels
automatically.
Using a mechanical polarizer for your LNB
For pre-positioned or fixed antenna installation, follow the steps below. Connect the appropriate leads to the output terminals
(R12) at the back of the receiver as shown.
PULSE GND
INSTALL MENU: ANTENNA SETTINGS
1. Antenna: Press VOL up / down and select reference 1.
LNB Type: Press VOL up / down and select ' Wide'. After selecting, press OK to configure the LO settings, if different.
LNB Power: Press VOL up / down and select '14V Skew On'. This will switch your LNB to lower band.
STORE: Press OK to store the settings.
2. Antenna: Press VOL up / down and select reference 2.
All manuals and user guides at all-guides.com
TV CHANNELS
This will display all the TV channels tuned in each TP. F=free-to-air channels.
S=scrambled channel.
RADIO CHANNELS
This will display all the Radio channels tuned in each TP. F=free-to-air
channels. S=scrambled channel.
+5V
+5V input to polarizer
Ground connection to polarizer
Pulse output to polarizer
11