Schläuche Einlegen; Inserting The Tubing; Insertion Des Tubes - Ismatec IP Mode D'emploi

Table des Matières

Publicité

aus/off
auf Rückwand
1
on rear panel
sur panneau arrière
2
3
ein/on
auf Rückwand
4
on rear panel
sur panneau arrière
16
Schläuche einlegen
1
Pumpe ausschalten.
2 Den 2-Stopper–Schlauch mit einem
Reiter in einen Adapter einsetzen. Den
Schlauch leicht spannen und mit dem
zweiten Reiter in den andern Adapter
einsetzen.
Achten Sie darauf, dass der Schlauch
zwischen den Reitern nicht verdreht ist.
3 Alle Kassetten auf die Pumpe zurück-
setzen und beidseitig einklinken
Pfeilrichtung auf Kassette
entspricht Fließrichtung mit
minimaler Pulsation.
(siehe auch Hinweis auf S. 30)
4 Pumpe einschalten und starten.
Bei längerem Stillstand empfehlen
wir, die Kassetten zur Schlauch-entla-
stung auf einer Seite
auszuklinken.

Inserting the tubing

1
Switch the pump off.
2 Insert the 2-stop tubing with one stop
into an adaptor.
Stretch the tubing slightly so that it can
be inserted with the second stop into the
other adaptor.
Ensure that the tube is not
twisted.
3 Reinsert all cassettes into the pump.
Ensure that they snap in on both sides.
The direction of the arrow engraved
on the cassette indicates the flow direc-
tion providing the least pulsation.
(also see information on page 30)
4 Switch the pump on and start it.
When the pump is idle, we
recommend you release the tubes from
pressure by disengaging all cassettes on
one side.

Insertion des tubes

1
Mettre la pompe hors service.
2 Insérer le tube à 2 manifolds avec un
manifold dans l'adaptateur.
Etirer légèrement le tube de manière à
pouvoir insérer le deuxième arrêt dans
l'autre adaptateur.
Ne pas tordre le tube!
3 Remettre toutes les cassettes sur la tête à
galets et les y fixer. Veiller à ce qu'elles
crochent bien des deux côtés.
La direction de la flèche gravée sur
la cassette indique le sens d'écoulement
qui génère la moindre pulsation.
(voir aussi page 30)
4 Remettre la pompe en service.
Lorsque la pompe n'est pas utilisée
pendant un certain temps, libérer les
cassettes de la languette de fixation sur
un côté.
IP_IP-N/03.22.10/SP

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ip-n

Table des Matières