Gaggenau DF 260 Notice D'utilisation page 17

Time Remaining PowerBeam®
Our Star-Sapphire® dishwashers offer a convenient Time Remaining PowerBeam® light that projects cycle status
and time remaining on the kitchen floor (all other models offer our blue PowerBeam® light to let you know the unit
is running).
Note: If the appliance is installed at eye-level, the time remaining information is not visible.
S:01 default setting:
In the default setting (S:01) the time remaining, selected cycle, delay start time and water intake testing are indi-
cated. Example: If you select a cycle and start your dishwasher in the S:01 (default) setting, the time remaining
image will display in rotation with the Star logo (about 5 seconds per image).
To change setting:
Open the door and press the ON/OFF button.
1
Hold down the A button and press and hold START until the display indicates "H:00".
2
Release both buttons. The LED for the A button flashes and display indicates "H:00".
3
Press the A button until the display shows "S:01".
4
Press the C button to switch between "S:00" = OFF, "S:01" and "S:02" = ON
5
Press START to save the setting and close the door.
6
Open the door.
Turn unit on by pressing the ON/OFF switch. The display of the last
Press the START button.
Close the door. The program starts running.
Open the door.
Press the ON/OFF button. The LEDs go out. The program is saved. If the door
was opened on an appliance which has a warm water connection or is heated,
the appliance.
To continue the program, switch on the ON/OFF switch again.
Close the door.
WARNING
To avoid risk of scalding, OPEN THE DOOR CAREFULLY during any wash or rinse cycle. Do not fully open
the door until water noises have stopped.
Open the door.
Close the door. The program sequence lasts approx. 1 min.
Open the door.
Press the ON/OFF button.
Close the door.
16
All manuals and user guides at all-guides.com
Time remaining image
logo