Toro Recycler 55 Manuel De L'utilisateur page 6

Setup
Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
1
Unfolding the Handle
No Parts Required
Procedure
WARNING
Unfolding the handle improperly can damage
the cables, causing an unsafe operating
condition.
• Do not damage the cable(s) when folding
or unfolding the handle.
• Ensure that the cable(s) are routed to the
outside of the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Disengage the handle locks
2. Move the handle rearward to the operating
position (Figure 3).
All manuals and user guides at all-guides.com
(Figure 3).
5
Figure 3
1. Handle lock engaged
position
3. Set the handle lock in 1 of the 2 positions
4) until the pin clicks in place to lock the handle
into the operating position.
Figure 4
1. Handle lock
g188439
2. Handle lock disengaged
positions
(Figure
g185991
2. Pin positions