Function; Choosing A Location - Abus Rm20 Consignes D'utilisation Et D'installation

CoMMISSIoNING
First of all, remove any activation
safeguards (e.g. a cotter pin) and
make sure that the activation safe-
guard does not get into the device!
Then press the device's activation
button (Fig. 1, I.) which is shown in
the picture on page 15. After the
button has been pushed in, it must
be flush with the unit's housing. If
the smoke alarm has been activated
successfully, a brief test tone sounds
to confirm activation. This test tone
will also sound when you press the
test and stop button (Fig. 1, IV) to
verify that the unit is operating
correctly.

FUNCTIoN

The heat alarm function is activated
under the following conditions:
• When the temperature is over 40°C
and rises by more than 4°C in
80 seconds
• If the temperature exceeds 60°C for
more than 8 seconds
MoAnltg RM 20_D_GB_F_NL_I_11.2012.indd 16
All manuals and user guides at all-guides.com
Bedroom
Children's
room
Living room
Kitchen
Boiler room
Workshop
room
– 16 –
• Heat alarm tone: single beep, once
a second
• Smoke alarm tone: double beep,
once a second

CHooSING A LoCATIoN

Fig. 2
RM
RM
RM
RM
Bathroom
Bedroom
RM
RM RM
Children's Children's
room room
RM
RM
RM
RM
RM
RM
RM
RM
RM
Kitchen
RM
Living room
14.11.12