Beko GNE134751X Mode D'emploi page 15

Installation
3.12 Things to do to have
the filter usage time
calculated automatically
(For products connected to the mains water
line and equipped with filter)
1- Plug in the refrigerator. Press A (key lock)
button simultaneously to enable the key lock.
2- Then press on the following buttons in turn.
3
4
3
4
1. Vacation button
2. Fridge temperature setting button
3. Quick Cool setting button
4. Freezer temperature setting button
When the buttons are pressed in the correct order,
Key Lock symbol will turn off, buzzer will sound
shortly and Filter Change Warning indicator will
turn on. When the Filter Replacement Warning
button is pressed on, filter usage times are started
to be calculated automatically.
C
If the filter usage time is calculated
automatically, Filter Change Warning
indicator will illuminate continuously in a
few seconds after the product is plugged
in.
C
Automatic filter usage time calculation is
not enabled ex factory. It must be enabled
in products equipped with a filter.
C
If the same procedure is repeated when
the automatic filter usage time calculation
is enabled, then the function will be
cancelled.
All manuals and user guides at all-guides.com
3.13 Before starting to use the
• If the water pressure is below 1 bar or a
• Water system of the refrigerator must be
• No water may be obtained in the initial start-
A
A
• During initial use, you will have to wait
2
• It will take around 1-2 days for the system to
2
1
• Water pressure must be between 1-8 bars for
1
• The first 10 glasses of water should not be
• You must wait approximately 12 hours to
• Do not consume the first 30 pieces (3-4 Litres)
• First several glasses of water may be turbid
• If the water dispenser is not used for a long
14 / 31 EN
water/ice dispenser
demijohn will be used, than a separate must be
used as well.
connected to the cold water line. It must not
be connected to hot water line.
up of the refrigerator. Because there is air in
the system. To discharge air from the system,
press dispenser latch for 1-2 minutes until
water comes from the dispenser. Water flow
may be irregular at the beginning. After the
air in the system is discharged, water flow will
return to normal.
approximately 12 hours for the water to cool
down.
produce required amount of ice.
the operation of ice/water dispenser smoothly.
For this, check that 1 glass of water (100 cc)
can be filled in 10 seconds.
consumed.
obtain ice from the ice dispenser for the first
time. If there is not enough ice in the ice
container, ice may not be obtained from ice
dispenser.
of ice cubes.
when the filter is used for the first time.
Therefore, do not consume the first several
glasses of water.
period of time, first 1-2 glasses of water can
be hot.
Refrigerator / User Manual