Beko GNE134751X Mode D'emploi page 11

Installation
3.9 Connecting of the water hose
to the cold water mains line
(in some models)
If you will use the refrigerator by connecting it
to the cold water mains line, you must install a
standard 1/2" valve connector to the cold water
installation of your home. If this valve is not present
or you are not sure, consult a qualified plumber.
1. Separate the union from the tap adaptor.
2. Install the tap adaptor to standard 1/2" valve
connector.
3. After inserting the water hose to the union,
install it to the tap adaptor and insert to the
union to the tap adapter.
4. Tighten the union by hand.
A
WARNING:
Secure the water hose
to suitable points by means of the
clips supplied to avoid any damage or
displacement or accidental disconnection.
A
WARNING:
After turning on the water
valve, make sure that there is no leakage
at both connection points of the water
hose. If there is a leakage, turn off the
valve immediately and tighten all joints
again using a spanner or a pliers.
A
WARNING:
Make sure that standard 1/2"
valve connector is available and completely
turned off on your cold water mains line.
All manuals and user guides at all-guides.com
10 / 31 EN
Refrigerator / User Manual