Detergent Dispenser - Hoonved AP 43 E Mode D'emploi Et D'entretien

Part 3: For the technician
3.3

DETERGENT DISPENSER

The machine is equipped with an automatic detergent
dispenser.
• Insert the supply tube into the cannister.
ATTENTION
Always wash the hands under running water if they come
into contact with detergent, or comply with the specific
indications pertaining to the utilized type of detergent.
• The detergent inlet is automatic at every water fill-in
in the tank.
To adjust the dispenser, refer to the relative enclosed
manual and to the utilized type of detergent.
To connect the detergent pump, use the specific termi-
nals inserted in the electrical system, marked "DD".
3.4 FILLING THE RINSING AGENT
DISPENSER
• Insert the tube into the cannister containing rinsing
agent.(Refer to the specific instructions given with the
rinsing agent itself).
• Start the machine as described in paragraph 2.1.
The dispenser will suck about 3 cm of liquid from the
cannister.
• Fill during the cycle by opening (slightly) and closing
the door until the tube has completely filled.
3.4.a Adjusting the dose
• Start the machine as described in paragraph 2.1 amd
hold a glass up to the light at the end of the cycle.
• The drops of water on the glass will indicate insufficient
dosage while, the streaking or spotting will indicate,
instead, an excessive dosage.
• Regulate by means of the plug , turning clockwise to
decrease the quantity or anticlockwise to increase it.
IMPORTANT
These data are indicative and not binding since they may
vary according to the hardness of the water or the utilized
type of detergent and rinsing agent.
ATTENTION
If the utilized product (detergent or rinsing agent) is
changed, it is advisable to flush out the dosing system
with water and to then proceed by filling the dispensers.
ENGLISH
39