Hoonved AP 43 E Mode D'emploi Et D'entretien page 38

ENGLISH
DYSPLAY ALARMS and
SIGNALS: SELF-DIAGNOSIS
when more than one alarm is detected simultaneously, the
relative codes will appear on the display in the following
order of priority:
1. H1-H2-H3
2. A1-A2-A3-A4-A5
3. F1-F2
The alarm and active function codes shown on the
display when the machine is in operation are:
- A1: FAILURE TO COMPLETE CYCLE
This alarm message appears when the machine
is switched back on after being switched off
using "Q1".
- A2 : BOILER OVERHEATING
This alarm message appears when the temperature
in the boiler exceeds 105°C;
(the cycle underway will be completed).
- A 3: TEMPERATURE PROBE DISCONNECTED
This alarm message appears if either or both of the
probe contacts are disconnected
(or if the probe is interrupted);
(the cycle underway will be completed).
- A 4: LACK OF WATER IN TANK
This alarm message appears if a lack of water is
detected in the tank or if tank level is not reached
within 90 sec.;
In this case, switch the machine OFF and ON
again.
5: BOILER FAILING TO HEAT
- A
This alarm message appears if the boiler fails to
heat within 30 minutes.
- H 1: RINSING WATER TEMPERATURE
This alarm message appears if, during the wash
cycle, the rinsing phase takes place with a boiler
temperature at least 15°C below the level set.
38
Part 3: For the technician
: NON-DRAINING OF THE TANK
- H2
This alarm occurs when the draining of the
water in the tank does not happen.
: WASHING WATER TEMPERATURE (TANK)
- H3
This alarm message appears if, during the wash
cycle, the washing phase takes place with a tank
temperature at least 10°C below the level set;
(the cycle underway will be completed).
: DOOR OPEN
- F1
This alarm message appears if the door is open.
- F2 : INITIAL FILL-UP
This alarm message appears when the machine is
filling up with water.
- C1 : SELF WASHING and DRAINING CYCLE
: MANUAL DRAINING CYCLE
- C2
- OFF: MACHINE SWITCHED OFF
- PSt : "PRESET" PARAMETERS