Hoonved AP 43 E Mode D'emploi Et D'entretien page 29

Part 2: For the operator
2.1 AP/FW E WASHING PHASES
2.1.a Machine OFF
When the machine is switched OFF the display will read
"OFF":
Q1 SI t1/t2
2.1.b Switching on and preparing the machine
To switch the machine on, press the "Q1" button. The
LED representing the last cycle selected wil
FLASH (LC1 - LC2 - LC3 -
I II III IIII
LC1LC2LC3LC4
ATTENTION
When switching on for the first time, the
will FLASH.
First the boiler then the tank will begin to fill automatically.
While the machine is filling up the display will read
"F2".
Once filled, the water-heating elements will be activated,
first in the boiler then in the tank.
The display will give the tank temperature;
IMPORTANT
It is advisable, when first switching on, to wait until
the display reads 55°C.
WASHING OPERATION
ATTENTION
When items to be washed are encrusted with burnt
on matter, or a long time has passed between use and
washing, it is essential to carry out a pre-wash soak
using a suitable softening agent.
The use of hand-washing products is to be avoided
as they could produce foam inside the machine.
IPlace the basket of items to be washed inside the machine,
having first removed any solid waste.
START
I II III IIII
LC1LC2LC3LC4
S9 S3
LC4).
LC2 light
2.1.c Cycle selection
Press the "S9" or CYCLE button to select the washing
cycle required from the 4 different cycles available
(SHORT, MEDIUM, LONG, INTENSIVE) and speci-
fically:
LC 1: SHORT CYCLE = * 152 sec.
LC 2: MEDIUM CYCLE = * 182 sec.
LC 3: LONG CYCLE
LC 4: INTENSIVE CYCLE = * 484 sec.
* without rinsing
2.1.d STARTING UP THE WASHING CYCLE
2.1.d.1 STARTING UP THE WASHING CYCLE
MANUALLY
To start up the cycle MANUALLY, press and hold the
START "S3" button for approx. 2 sec.
The LEDs of the display will light on in sequence and the
message shown on the display will blink (indicating that
the cycle is underway) at the LED for the selected cycle
will FLASH (e.g., LC2);
I II III IIII
LC1
Display cycle underway LED
2.1.d.2 STARTING UP THE WASHING CYCLE AUTO-
MATICALLY
To start up the cycle AUTOMATICALLY (by opening and
closing the door), you will need to change the cycle
start-up mode. Press and hold the START "S3" button
until the pre-selected cycle LED remains CONSTAN-
TLY LIT (approx. 10 sec.) and the washing cycle will
then start up AUTOMATICALLY when the door is
closed.
2.1.e Instructions during the washing cycle
2.1.e.1 Display information
1) During washing, the tank temperature is indicated and
the display LEDs light up in sequence.
Display cycle underway LED
2) During drip-drying, only the display LEDs light up.
ENGLISH
= * 242 sec.
LED for pre-selected cycle
LC2 LC3 LC4
I II III IIII
LC1 LC2 LC3 LC4
I II III IIII
LC1 LC2 LC3 LC4
29