Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
WArning:
from the power source before adjusting, adding accessories, or checking a
function on the tool.
Attaching Column To Base (FIG 3)
1. Set the base (1) on the level, flat floor.
2. Place the column tube (2) on the base (1), align
the three holes in the column support with the
holes in the base.
3. Install a set of bolt and washers (3) in each
column support hole and tighten with the
wrench.
Installing the Table Assembly (FIG 4)
1. Loosen the table lock handle (4).
2. Slide the table assembly down onto the column (2).
3. Position the table assembly (5) in the same direction
as the base.
4. Tighten the table lock handle (4).
Installing Chuck, Head Assembly and
Feed Handles (FIG 5)
1. Place the head assembly upside down on a
level, flat surface.
2. Position chuck (6) on spindle. Chuck should be
fully opened to avoid damaging jaws.
3. using a piece of scrap wood to protect the
chuck, firmly tap the chuck into place using a
mallet or hammer.
4. Position the head assembly onto the column(2)
with the chuck positioned over the table (5).
5. Slide the head assembly down as far as it will
go. Align the direction of the drill press head
with the direction of the table and the base,
then tighten the two head set screws (7) with
the Allen wrench provided.
6. Attach the three feed handles (8) by screwing
them into the threaded holes in the hub (9).
Mounting the Drill Press
If the drill press is to be used in a permanent location, secure it to a workbench or other stable
surface by inserting the appropriate mounting hardware through the two predrilled holes (10-fIG 4) in
the base.
If the drill press is to be used as a portable tool, fasten it permanently to a mounting board that can
easily be clamped to a workbench or other stable surface. The mounting board should be of sufficient
size to avoid tipping while drill press is in use. Any good grade plywood or chipboard with a 3/4"
thickness is recommended.
Always be sure that the tool is switched off and unplugged
Fig 3
Fig 4
5
10
9
6
5
2
3
1
4
2
7
8
2
Fig 5
9
Publicité
