Genesis GDP500 Manuel D'utilisation page 11

Squaring the Table to the Head (FIG 10)
1. Install a 3" long drill bit (1) into the chuck (2).
2. Raise and lock the table (3) about 1" from the end of
the drill bit.
3. Place a combination square (4) on the table as shown.
The drill bit should be parallel to the straight edge of
the square.
4. If an adjustment is needed, loosen the bevel lock (3-
fIG8 ) with a wrench.
5. Square the table to the bit by tilting the table.
6. Tighten the bevel lock bolt (3-fIG 8) when square.
Adjusting the play of Spindle (FIG 11)
NOTE: The spindle was properly adjusted at the factory
and should not be readjusted unless necessary.
Move the spindle to the lowest downward position and
hold in place. With your other hand, try to make it
revolve around its axis with a side motion. If there is too
much play proceed as follows:
1. Loosen the lock nut (1).
2. Turn the screw (2) clockwise to eliminate the play but
without obstructing the upward and downward motion
of the spindle (a little bit of play is normal).
3. Tighten the lock nut (1).
OPErATiOn
ON/OFF Switch (FIG 12)
1. To turn the saw ON, move the switch (1) to the"ON"
position.
2. To turn the saw Off, move the switch (1) to the "Off"
position.
3. To lock the switch in the Off position, remove the safety
key (2) from the switch. Store the key in a safe place.
Rotating the table (FIG 8- Page 10)
The table can be rotated out of the way when drilling a large piece.
1. Loosen the table lock handle (1).
2. Rotate the table (2) to desired position.
3. Retighten the lock handle before drilling.
Fig 10
1
3
Fig 11
1
2
Fig 12
1
2
2
4
11