AVS Ventvisor Deflector Serie Instructions D'installation page 2

Installation Steps
Scuff the rubber trim where the visor will
mount with the scotch brite pad. Then clean
the trim with an alcohol pad and wipe dry.
Repeat on opposite door.
1
Peel back 2" of tape liner from back of front visor at
each end of top flange.
top flange
front
3
flange
Remove remaining tape liner.
5
NOTE: Actual application may vary slightly from illustrations.
rear
flange
Apply one coat of surface prep to the previ-
ously cleaned rubber trim on both front doors
2
Align front visor with previously cleaned surface.
4
Apply pressure to secure visor to vehicle.
6
Repeat above steps for opposite side.
Page 2 of 3
promptly to prevent evaporation.