Toro Recycler 20376 Manuel De L'utilisateur page 9

Starting the Engine
Note: You can start the engine either from the operating
position (Figure 12) or at the engine (with the recoil-start
handle out of the rope guide).
Pull the recoil starter lightly until you feel resistance, then pull
it sharply. Allow the rope to return to the handle slowly.
Note: If the machine does not start after several attempts,
contact an Authorized Service Dealer.
Using the Self-propel Drive
To operate the self-propel drive, simply walk with your hands
on the upper handle and your elbows at your sides, and the
machine will automatically keep pace with you (Figure 13).
Note: If the machine does not freely roll backward after
self-propelling, stop walking, hold your hands in place, and
allow the machine to roll a couple of inches (centimeters)
forward to disengage the wheel drive. You can also try
reaching just under the personal pace handle to the metal
handle and push the machine forward a couple of inches
(centimeters). If the machine still does not roll backward
easily, contact an Authorized Service Dealer.
Figure 12
Figure 13
Stopping the Engine
To stop the engine, press and hold the ignition switch
(Figure 14) until the engine stops.
1. Ignition switch
Important: When you press and hold the ignition
switch, the engine should stop within 3 seconds. If
it does not stop properly, stop using your machine
immediately and contact an Authorized Service Dealer.
Engaging the Blade
When you start your engine, the blade does not turn. You
must engage the blade to mow.
1. Pull the control-bar lock back (Figure 15).
2. Pull the blade-control bar to the handle (Figure 16).
3. Hold the blade-control bar against the handle
(Figure 17).
9
G020233
Figure 14
Figure 15
Figure 16