Toro Recycler 20376 Manuel De L'utilisateur page 11

If the side-discharge chute is on the machine, remove it;
refer to Removing the Side-discharge Chute (page 13) before
bagging the clippings. If the bag-on-demand lever is in the
recycling position, move it to the bagging position; refer to
Operating the Bag-on-Demand Lever (page 11).
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Grass Bag
1. Raise and hold up the rear deflector (Figure 19).
1. Notches
2. Rear deflector
2. Install the grass bag, ensuring that the pins on the bag
rest in the notches on the handle (Figure 19).
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps above.
Operating the Bag-on-Demand Lever
The bag-on-demand feature allows you to either collect or
recycle grass and leaf clippings while the grass bag is attached
to the machine.
11
G020245
Figure 19
3. Grass bag pin (2)