Toro Recycler 20376 Manuel De L'utilisateur page 17

WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
1. Disconnect the spark-plug wire from the spark plug.
Refer to Preparing for Maintenance (page 15).
2. Tip the machine onto its side with the dipstick down.
3. Remove the 2 blade nuts and the stiffener (Figure 27).
Figure 27
1. Blade nuts
4. Remove the blade (Figure 27).
5. Install the new blade (Figure 27).
6. Install the stiffener that you previously removed.
7. Install the blade nuts and torque them to 15 to 27 ft-lb
(20 to 37 N-m).
2. Stiffener
Cleaning the
Blade-brake-clutch Shield
Service Interval: Every 25 hours
Clean the blade-brake-clutch shield yearly to prevent the blade
from stalling while you mow.
1. Disconnect the spark-plug wire from the spark plug.
Refer to Preparing for Maintenance (page 15).
2. Tip the machine onto its side with the dipstick down.
3. Remove the 2 blade nuts and the stiffener (Figure 28).
1. Blade nuts
2. Stiffener
3. Blade
4. Remove the blade (Figure 28).
5. Remove the blade driver and disk (Figure 28).
6. Remove the blade brake-clutch shield (Figure 28).
7. Brush or blow out debris from the inside of the shield
and around all the parts.
8. Install the blade-brake-clutch shield that you previously
removed.
9. Install the blade driver and disk that you previously
removed.
10. Install the blade and the stiffener that you previously
removed (Figure 28).
11. Install the blade nuts and torque them to 15 to 27 ft-lb
(20 to 37 N-m).
17
Figure 28
4. Blade driver
5. Disk
6. Blade-brake-clutch shield